Lenovo x3650 M4 BD 5466, Инструкция по установке и обслуживанию

Страница: 293 / 1222

Maximal card dimension supported in each slot (rear view)
1 Full height , up to full length 4 Full height , up to full length
2 Full height, half length 5 Full height , up to full length
3 Full height, half length 6 Full height, half length
(Riser 1) (Riser 2)
Note: If you are replacing a high power graphics adapter, you might need to disconnect the internal power
cable from the system board before removing the adapter.
To remove an adapter, complete the following steps:
00
00000
00000
00000
000000
000000
000000
000000
00000
00000
00000
0000000
0000000
0000000
0000000
0000000
00
0
PCI
riser-card
assembly
(in long position)
Adapter
Adapter
connectors
PCI
riser-card
assembly
(in short position)
Adapter
Adapter
connectors
Full-length
adapter
bracket
Full-length
adapter
bracket
Figure 193. Adapter removal
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the
cover (see “Removing the cover” on page 240).
Step 3. Press down on the left and right side latches and slide the server out of the rack enclosure until
both slide rails lock; then, remove the cover (see “Removing the cover” on page 240).
Step 4. Remove the PCI riser-card assembly that contains the adapter (see “Removing a PCI riser-card
assembly” on page 37).
• If you are removing an adapter from PCI expansion slot 1, 2, or 3, remove PCI riser-card
assembly 1.
• If you are removing an adapter from PCI expansion slot 4, 5, or 6, remove PCI riser-card
assembly 2.
Step 5. Disconnect any cables from the adapter (make note of the cable routing, in case you reinstall
the adapter later).
Step 6. Carefully grasp the adapter by its top edge or upper corners, and pull the adapter from the PCI
expansion slot.
Step 7. If the adapter is a full-length adapter in the upper expansion slot of the PCI riser-card assembly
and you do not intend to replace it with another full-length adapter, remove the full-length-adapter
bracket and store it on the underside of the top of the PCI riser-card assembly.
Chapter 6
.
Removing and replacing components
281