Lenovo x3650 M4 BD 5466, Инструкция по установке и обслуживанию

Страница: 163 / 1222

While the server is turned off, move power-on password switch (switch 4) on the system board switch
block (SW3) to the On position to enable the power-on password override. You can then start the Setup
utility and reset the power-on password. You do not have to return the switch to the previous position.
The power-on password override switch does not affect the administrator password.
Administrator password
If an administrator password is set, you must type the administrator password for access to the full Setup
utility menu. You can use any combination of 6 to 20 printable ASCII characters for the password.
Attention: If you set an administrator password and then forget it, there is no way to change, override,
or remove it. You must replace the system board.
Using the Boot Manager
The Boot Manager program is a built-in, menu-driven configuration utility program that you can use to
temporarily redefine the first startup device without changing settings in the Setup utility.
To use the Boot Manager program, complete the following steps:
Step 1. Turn off the server.
Step 2. Restart the server.
Step 3. When the prompt
<F12> Select Boot Device
is displayed, press F12.
Step 4. Use the Up arrow and Down arrow keys to select an item from the menu and press Enter.
The next time the server starts, it returns to the startup sequence that is set in the Setup utility.
Starting the backup server firmware
The system board contains a backup copy area for the server firmware. This is a secondary copy of the
server firmware that you update only during the process of updating the server firmware. If the primary copy
of the server firmware becomes damaged, use this backup copy.
To force the server to start from the backup copy, turn off the server; then, place the UEFI boot backup
jumper (JP2) in the backup position (pins 2 and 3). See “System-board switches, jumpers, and buttons”
on page 29 for the location of the UEFI boot backup jumper (JP2).
Use the backup copy of the server firmware until the primary copy is restored. After the primary copy is
restored, turn off the server; then, move the UEFI boot backup jumper (JP2) back to the primary position
(pins 1 and 2).
The Update Xpress System Pack Installer
The Update Xpress System Pack Installer detects supported and installed device drivers and firmware in the
server and installs available updates.
For additional information and to download the Update Xpress System Pack Installer, go to the ToolsCenter
for System x and BladeCenter at http://publib.boulder.ibm.com/infocenter/toolsctr/v1r0/ and click
UpdateXpress System Pack Installer .
Using the integrated management module
The integrated management module (IMM) is a second generation of the functions that were formerly
provided by the baseboard management controller hardware. It combines service processor functions, video
controller, and remote presence function in a single chip.
Chapter 3
.
Configuration information and instructions
151