Lenovo x3650 M4 BD 5466, Инструкция по установке и обслуживанию

Страница: 327 / 1222

Hard disk drive
backplane
SAS
signal
cable
Power
cable
Configuration
cable
Figure 224. 2.5-inch simple-swap/hot-swap hard disk drive backplate assembly/backplane installation
Step 6. Replace the fan bracket and fans if you removed them (see “Replacing the fan bracket” on page
276 and “Replacing a hot-swap fan” on page 312).
Step 7. Reinstall the hard disk drives (see “Replacing a hot-swap hard disk drive” on page 250).
Step 8. Install the cover (see “Replacing the cover” on page 240).
Step 9. Slide the server into the rack.
Step 10. Reconnect the power cords and any cables that you removed.
Step 11. Turn on the peripheral devices and the server.
Removing the 3.5-inch simple-swap/hot-swap hard disk drive backplate
assembly/backplane
Use this information to remove the 3.5-inch simple-swap/hot-swap hard disk drive backplate
assembly/backplane.
To remove the 3.5-inch simple-swap/hot-swap hard disk drive backplate assembly/backplane, complete the
following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines”
on page 34.
Step 2. Turn off the server and peripheral devices and disconnect all power cords.
Step 3. Remove the cover (see “Removing the cover” on page 240).
Step 4. Pull the hard disk drives or fillers out of the server slightly to disengage them from the backplate
assembly/backplane. See “Removing a simple-swap hard disk drive” on page 252 for details.
Step 5. To obtain more working room, remove the fans (see “Removing a hot-swap fan” on page 311).
Step 6. Lift the backplate assembly/backplane out of the server by pulling the latch and lifting it up.
Chapter 6
.
Removing and replacing components
315