LEGRAND 1U, Руководство пользователя, Страница: 398 / 543

Janu
ary 201
9
398 Legrand PDU User Guide
Option Description
A numeric
value Sets a value for the specified threshold of a
specific inlet sensor and enables this threshold at
the same time.

<hy_value> is a numeric value that is assigned to the hysteresis for the specified inlet sensor. See
"To
De-assert" and Deassertion Hysteresis
(on page 513).

<as_value> is a numeric value that is assigned to the assertion timeout for the specified inlet sensor.
See
"To Assert" and Assertion Timeout
(on page 511).

Additional sensors supported by Legrand PDUs:
The CLI command(s) listed above can be also applied to the following sensors. Note that the measurement
unit of current values in CLI is
A
, not mA.
Sensor type Description
peakCurrent Peak current sensor
reactivePower Reactive power sensor
displacementPowerFa
ctor Displacement power factor sensor
phaseAngle Inlet phase angle sensor
Commands for Inlet Pole Sensors
A sensor configuration command for inlet poles begins with
sensor inletpole
. This type of command is
available on a three-phase PDU only.
You can configure various inlet pole sensor threshold settings at a time by combining multiple commands.
See
Multi-Command Syntax
(on page 408).

Set the Upper Critical Threshold for an Inlet Pole:
config:# sensor inletpole <n> <p> <sensor type> upperCritical <option>

Set the Upper Warning Threshold for an Inlet Pole:
config:# sensor inletpole <n> <p> <sensor type> upperWarning <option>

Set the Lower Critical Threshold for an Inlet Pole:
config:# sensor inletpole <n> <p> <sensor type> lowerCritical <option>

Set the Lower Warning Threshold for an Inlet Pole:
config:# sensor inletpole <n> <p> <sensor type> lowerWarning <option>

Set the Inlet Pole's Deassertion Hysteresis:
config:# sensor inletpole <n> <p> <sensor type> hysteresis <hy_value>

Set the Inlet Pole's Assertion Timeout: