LC Packings Probot 161403, Руководство пользователя

Страница: 35 / 118

Installation and Getting Started
User’s Manual Probot
D960R3
2-15
2.7 µCarrier – First Steps
2.7.1 Launching µCarrier
When µCarrier is opened for the first time, the following window appears
(FIGURE 2-8):
FIGURE 2-8 The Run a Real Device? Window
a) Choose the Yes button if you want to control Probot (all available COM ports
will then be scanned until µCarrier will detect the instrument), choose the No
button if you want to launch the software in offline mode.
Note: Depending on the position of the table, one or more of the security
switches may be activated. If a switch is activated, a corresponding message is
presented and the Probot will perform reference runs.
b) In the next window that appears you will be asked whether or not a dosage
module is present in your Probot. Choose the Yes button if there is one
present or choose the
No
button if not (FIGURE 2-9).
FIGURE 2-9 The Dosage Module Installed? Window
c) After initializing of the Probot (when running in ‘real device’ mode only) the
µ Carrier software is ready and the Main Screen will be presented
(FIGURE 2-10).
Note: After the initial launch of µCarrier, the last saved application is
automatically loaded when µCarrier is opened. In the case the last saved
application could not be loaded, µCarrier will present the
Main Screen
( FIGURE 2-10) again.