Kobelco SK235SR-2, Руководство по эксплуатации

Страница: 253 / 308

1.
Load machine on firm and level ground.
2.
Do not fail to put blocks to the tire of trailer to
prevent machine from moving.
3.
The width and height of the loading area
(earthen bank or loading platform ramp) must
be high enough to match the trailer and wide
enough to match the width of the machine and
trailer, or wider.
4.
Make sure the machine position is aligned to
ramps before traveling up the ramps, and
travel slowly with the dozer (if equipped), raised
position. The arm and boom held at angle
shown in the figure, and the dozer equipped
and attachment lowered as much as possible
but do not interfere with trailer bed. And travel
５
5.1.2 LOADING/UNLOADING THE MACHINE
-The machine loading and unloading work should be carried out on the firm and level ground.
-Use ramps which have sufficient width, length, thickness and strength.
-Slow speed traveling is necessity to load and unload the machine.
-It is hazardous to use the attachment for loading and unloading the machine. Do not use the
attachment for loading and unloading.
-Use only the traveling controls when the machine is on the ramp.
-Be prepared for a change in the machine position as the machine travels up or down the ramp.
The machine may rock forward or rearward as the machine center of gravity changes when traveling
on the ramp or on the border between the track/trailer and the ramp.
-Turn auto accel switch off surely. The operation with the auto accel switched on may cause sudden
engine speed change.
-Remove mud, etc. of the crawler track link of machine surely to prevent skidding.
And remove water, snow, grease oil, etc. surely.
-Do not change the course on the ramps to prevent rolling over. Return to ground or trailer's bed once
and change the traveling direction.
A. In Cases where Making Use of ramps
［ 5. TRANSPORTATION ］
5-5
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]