Kobelco SK235SR-2, Руководство по эксплуатации

Страница: 200 / 308

1.
Move the machine to a firm level surface and
place the bucket on the ground, making
certain that the bucket is stable.
2.
Roll "O-rings" (1) onto the bucket bosses.
3.
Remove retaining ring and pin for bucket pin
(2) and for link pin (3). And remove bucket pin
(2) and link pin (3).
A: Safety Block
4.
Rotate arm 180 degrees with the arm slightly
raised (B) and bucket in place, and lower the
arm again and the pin bore position is changed.
5.
Clean pins for each part and pin bores and
then apply grease sufficiently.
6.
Fit O-ring (1) in place
7.
Align each pin bore, and insert pin. After
inserting pin, fix the pin with retaining ring and
pin.
8.
After attaching, rotate bucket softly to the stroke
end in engine low idling condition and check
that there is no interference of each section.
F. Reversing Backhoe Bucket
The backhoe bucket which is reversed 180 degrees is available for shoveling work. When working in
team, follow the signals exactly and pay particular attention to the safety.
-Be careful about the use of bucket for shoveling work because the bucket operation is reversed
when compared to that for the work with backhoe.
-When the 2.94 m (9'-8") arm is used, do not reverse the bucket. If the bucket is reversed, the bucket
bumps against arm by shoveling and it results damaging attachment.
［ 4. MAINTENANCE ］
4-32
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]