Kobelco SK235SR-2, Руководство по эксплуатации

Страница: 138 / 308

1. Put attachment on the ground, return all
control levers to neutral position and then
lock the safety lever.
2. Set the starter key switch to "OFF" for both
boost vehicle and disabled machine.
3. Connect the booster cable (red) clip to the
positive (+) terminal on the battery of
disabled machine.
4. Connect the clip from the other end of the
positive (+) booster cable (red) to the
positive (+) terminal on the battery of boost
vehicle.
5. Connect the booster cable (black) clip to
the negative (-) terminal on the battery of
boost vehicle.
6. Finally, connect the clip from the other
end of the negative (-) booster cable
(black) to the upper frame of disabled
machine, away from the battery.
7. Start the engine of boost vehicle, and run it
for about 10 minutes at high idle.
8. Start the engine of disabled machine.
9. After starting the engine of disabled
machine, remove the booster cables in the
reverse order of the above connection order.
10. Check and repair the cause of the
problem of the charging system on the
disabled machine.
D. Connecting / Disconnecting Booster Cables
Make sure the starter key switch is in the OFF position before connecting the booster cables.
Proceed as follows to connect and disconnect the booster cables.
AVOID EXPLOSION
-Wrong connection of booster cables may cause explosion of the batteries. Pay special attention while
connecting and disconnecting the booster cables.
-The starting system of this machine is 24 volts. Therefore the boost battery voltage in use should be
24 volts.
The application of high voltage employed for welding machine, etc. to start the engine may cause
damage to the electric system.
［ 3. MACHINE OPERATION ］
3-16
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]