Technical Reference Manual
002-29852 Rev. *B
Bits Name
SW
HW
Default or
Enum
Description
31
DEBUG_RUN
RW
R
0
Pauses/runs this counter while a debugger is
connected. Other behaviors are unchanged during
debugging, including service, configuration updates
and enable/disable. Note it may take up to two clk_lf
cycles for the counter to pause, due to internal
synchronization.
When (DEBUG_RUN==1 or
DEBUG_TRIGGER_EN==0) and the debugger is
connected for at least two clk_lf cycles, the
LOWER_ACTION is ignored until after the first service
after the debugger is disconnected. After the debugger
is disconnected, the LOWER_ACTION is ignored until
after the first service. This prevents an unintentional
trigger of the LOWER_ACTION before the firmware
realigns the servicing period. After the first service,
LOWER_ACTION behaves as configured. If the
debugger is disconnected before two clk_lf cycles, the
LOWER_ACTION may or may not be ignored.
0: When debugger connected, counter pauses
incrementing as configured in DEBUG_TRIGGER_EN.
1: When debugger connected, counter increments
normally, but reset generation is blocked. To block
LOWER_ACTION fault generation, write
DEBUG_TRIGGER_EN==0.
1721
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers