Technical Reference Manual
002-29852 Rev. *B
23.9.34 SCB_INTR_SPI_EC
Description:
Externally clocked SPI interrupt request
Address:
0x40600EC0
Offset:
0xEC0
Retention:
Retained
IsDeepSleep:
No
Comment:
The fields in this register are set by HW and are cleared by software by writing a '1'. These
interrupt causes are generated by externally clocked logic. HW clears the interrupt causes to
'0', when the IP is disabled.
Default:
0x0
Bit-field Table
Bits
7
6
5
4
3
2
1
0
Name
None [7:4]
EZ_READ
_STOP
[3:3]
EZ_WRITE
_STOP
[2:2]
EZ_STOP
[1:1]
WAKE_UP
[0:0]
Bits
15
14
13
12
11
10
9
8
Name
None [15:8]
Bits
23
22
21
20
19
18
17
16
Name
None [23:16]
Bits
31
30
29
28
27
26
25
24
Name
None [31:24]
Bit-fields
Bits Name
SW
HW
Default or
Enum
Description
0
WAKE_UP
RW1C
A
0
Wake up request. Active on incoming slave request
when externally clocked selection is '1'.
Only used when CTRL.EC_AM_MODE is '1'.
1
EZ_STOP
RW1C
A
0
STOP detection. Activated on the end of a every
transfer (SPI deselection).
Only available in EZ and CMD_RESP mode and when
CTRL.EC_OP_MODE is '1'.
2
EZ_WRITE_STOP
RW1C
A
0
STOP detection after a write transfer occurred.
Activated on the end of a write transfer (SPI
deselection). This event is an indication that a buffer
memory location has been written to. For EZ mode: a
transfer that only writes the base address does NOT
activate this event.
Only used in EZ and CMD_RESP modes and when
CTRL.EC_OP_MODE is '1'.
3
EZ_READ_STOP
RW1C
A
0
STOP detection after a read transfer occurred.
Activated on the end of a read transfer (SPI
deselection). This event is an indication that a buffer
memory location has been read from.
Only used in EZ and CMD_RESP modes and when
CTRL.EC_OP_MODE is '1'.
1432
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers