Technical Reference Manual
002-29852 Rev. *B
Bits Name
SW
HW
Default or
Enum
Description
25
RX_HEADER_SYNC
_ERROR
RW1C
RW1S
0
HW sets this field to '1', when the received
synchronization field is not received within the
synchronization counter range [106, 152] (see
TX_RX_STATUS.SYNC_COUNTER).
Note: The ongoing message transfer is aborted
(INTR.RX_HEADER_SYNC_DONE is NOT activated)
and the TX_HEADER, TX_RESPONSE and
TX_WAKEUP commands are set to '0'.
26
RX_HEADER_PARITY
_ERROR
RW1C
RW1S
0
HW sets this field to '1', when the received PID field
has a parity error.
Note: The ongoing message transfer is aborted
(INTR.RX_PID_DONE is NOT activated) and the
TX_HEADER, TX_RESPONSE and TX_WAKEUP
commands are set to '0'.
+G119 HW sets this field to '1', when the received data
field has a parity error (when CTL0.PARITY_EN is '1').
27
RX_RESPONSE_FRAME
_ERROR
RW1C
RW1S
0
HW sets this field to '1', when the received START or
STOP bits have an unexpected value (during response
reception). HW does NOT use this field for the STOP
bits of the first data field after a RX_HEADER
command, if the received data byte is 0x00.
(STATUS.RX_DATA0_FRAME_ERROR is used
instead).
Note: The ongoing message transfer is aborted
(INTR.RX_RESPONSE_DONE is NOT activated) and
the TX_HEADER, TX_RESPONSE and TX_WAKEUP
commands are set to '0'.
28
RX_RESPONSE
_CHECKSUM_ERROR
RW1C
RW1S
0
HW sets this field to '1', when the calculated checksum
over the received PID and data fields is not the same
as the received checksum.
Note: The ongoing message transfer is aborted
(INTR.RX_RESPONSE_DONE is NOT activated) and
the TX_HEADER, TX_RESPONSE and TX_WAKEUP
commands are set to '0'.
1064
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers