6
FORK, TRIPLE CLAMP
- Check the surface of the sliding bushings.
24
If the bronze-colored layer
G
under sliding layer
C,
is visible or the surface
is rough:
�
e
200665-10
200666-10
- Change the sliding bushings.
- Check the spring length.
Guideline
I
Spring length with preload spacer(s)
I
472 mm (18.58 in)
If the measured value is larger than the specified value:
- Reduce the thickness of the preload spacers.
If the measured value is smaller than the specified value:
- Increase the thickness of the preload spacers.
Assemblin the seal rin retainer
Info
The steps are identical for both fork legs.
- Mount and grease seal ring
O.
I
Lubricant (T158) (.- p. 257)
- Mount and grease O-ring
8.
I
Lubricant (T158) (.- p. 257)
Position pilot bushing support (D.
Assembling the h�drosto� unit
Info
The steps are identical for both fork legs.
- Mount and grease O-ring
O.
I
Lubricant (T158) (.- p. 257)
- Mount washer
8.
- Mount shim stack (D with the smaller washers facing downward.
- Mount the new O-ring on hub
C,.
- Mount the hub with washers
0.
•
Info
I
It is possible that only one or no washer is present.
- Mount and tighten adapter (D.
Guideline
I
Hydrostop unit adapter
I
M6x0.5
I 7 Nm (5.2 lbf ft)
Содержание FE 350 2014
Страница 2: ......
Страница 241: ...29 WIRING DIAGRAM Components A11 EFI control unit 832 Fuel level indicator F1 Fuse P13 Speedometer 239 ...
Страница 253: ...29 WIRING DIAGRAM Components A11 EFI control unit 832 Fuel tank sensor F1 Fuse P13 Speedometer 251 ...
Страница 272: ...32 SPECIAL TOOLS 270 Nitro en filling tool Art no T170S1 2x 3x T170S1 H00855 01 ...