HP MSR SERIES, Руководство по настройке

Страница: 186 / 889

169
• Enter IP address 192.168.1.5 , the IP address of Host C.
•
Select Hold Time and set the hold time of this blacklist entry to 50 minutes.
•
Click Apply .
# Configure intrusion detection on Ethernet 0/2: Enable scanning attack protection, and enable blacklist
function for it; enable Land attack protection and Smurf attack protection.
•
Select Security Setup > Attack Defend > Intrusion Detection from the navigation tree. Click Add and
then perform the following configurations, as shown in Figure 173 .
Figure 173 Configuring intrusion detection
•
Select interface Ethernet0/2 .
• Select Enable Attack Defense Policy .
• Select Enable Land Attack Detection , Enable Smurf Attack Detection , Enable Scanning Attack
Detection , and Add Source IP Address to the Blacklist . Clear all other options.
•
Click Apply .
Verifying the configuration
•
Select Security Setup > Attack Defend > Blacklist . Host D and Host C are in the blacklist.
•
Router drops all packets from Host D unless you remove Host D from the blacklist.
• Router drops packets from Host C within 50 minutes. Then, Router forwards packets from Host C
correctly.
•
Upon detecting the scanning attack on Ethernet 0/2, Router outputs an alarm log and adds the IP
address of the attacker to the blacklist. You can view the added blacklist entry by selecting
Security
Setup > Attack Defend > Blacklist .