horsch Leeb 5.280 VL, Руководство по эксплуатации

Страница: 251 / 308

Spraying operation
¾
Before starting the spraying operation exactly
determine the necessary application quan-
tity by using the instructions for use issued
by the crop protection agent manufacturer.
¾
Enter the required application quantity (nomi-
nal quantity) into the terminal before starting
the spraying operation.
¾
Strictly adhere to the required application
quantity [l/ha] during spraying operation,
•
to achieve an optimal treatment success
with this crop protection measure.
•
to avoid unnecessary impact on the en-
vironment.
¾
Choose the required nozzle type from the
spraying table before starting spraying – un-
der due consideration
•
of the intended travel speed.
•
required application quantity.
•
required atomizing characteristic (fine,
medium, or large drops) of the crop pro-
tection agent used for the crop protection
measure to be carried out.
•
recommended distances.
¾
See also chapter Nozzle selection .
¾
Choose the required nozzle size from the
spraying table before starting spraying –
under due consideration
•
of the intended travel speed.
•
of the required application quantity.
•
the planned spraying pressure.
¾
See also chapter
Nozzle selection
.
¾
Choose a slow travel speed and a low spray-
ing pressure to prevent losses by windward
drifting!
¾
See also chapter Nozzle selection .
¾
Apply additional measures for windward drift
reduction at wind speeds of 3 m/s [9 ft/s].
¾
See chapter Measures for windward drift re-
duction .
¾
Do not apply at average wind speeds higher
than 5 m/s [16 ft/s].
¾
Switch the nozzles on and off only when driv -
ing to avoid overdosing.
¾
Avoid overdosing caused by overlapping
•
in case of inaccurate joining passes from
one spraying track to the next and/or
•
when cornering at the headland with
spraying boom switched on!
¾
Switch off the outer sections if the edge of
the cultivation area runs at an angle to the
cultivation area.
¾
During spraying operation keep an eye on
the actual spraying mixture consumption in
relation to the treated area. In case of discrep-
ancies between the actual and the displayed
placing quantity calibrate the flow meter.
¾
Teach procedures must be carried out by
HORSCH service staff.
¾
In case of deviations between the actual and
the displayed distance calibrate the position
sensor (pulses per 100 m [328 ft]). This ac-
tivity should always be executed in the field.
¾
Teach procedures must be carried out by
HORSCH service staff.
¾
In case of weather related interruptions of
spraying operation it is mandatory to clean
filters, pump, fitting and spraying lines!
MF 247