horsch Leeb 5.280 VL, Руководство по эксплуатации

Страница: 198 / 308

Assembly accessories
1
2
3
4
1 GPS receiver
2 Metal plate
3 Magnetic base
4 Self-adhesive plate
1. Thoroughly clean the location where the GPS
receiver shall be mounted with alcohol.
¾
Installation on the fresh water tank
2. Glue the double-sided self-adhesive plate (4)
on the cleaned surface.
3. Clean the metal plate (2).
4.
Pull the paper off the self-adhesive plate (4)
and glue the metal plate (2) onto it.
5. Screw the magnetic base (3) into the GPS
receiver (1).
6. Position the GPS receiver (1) with the mag-
netic base on the metal plate (2).
GPS receiver mounted on spraying mixture container
Connecting the GPS receiver to the ter-
minal
CAUTION
The plug of the terminal carries voltage. Damag-
es to the terminal may occur from a short-circuit.
Switch off the terminal before connecting the
connecting cable of the GPS receiver to it!
1.
Switch off the terminal.
2. Route the connecting cable of the GPS re-
ceiver into the vehicle cabin.
3. Connect the connecting cable to the RS232
port on the terminal.
¾
For more information about the fitting con -
nection, refer to the HORSCH Terminal
TOUCH 1200 operating instructions.
4. During initial starting it may take up to 30 min-
utes until the GPS receiver has reception.
For all other starts it will only take approx.
1 - 2 minutes.
NOTE
Information on the configuration of the GPS
receiver is provided in the HORSCH brief in-
structions GPS Setting.
Technical data
Features
Operating voltage 7 - 36 VDC
Current consumption 249 mA at 12 VDC
Power consumption < 3 W at 12 VDC
GPS Standard
NMEA 0183
Configuration
Frequencies 5 Hz (GPGGA, GPVTG)
1 Hz (GPGSA, GPZDA)
Transfer rate 19200 Baud
Data bits 8
Parity no
Stop bits 1
Flow control none
When installing the GPS receiver, the geometric
data from the following table must be entered.
194 195