horsch Leeb 5.280 VL, Руководство по эксплуатации

Страница: 292 / 308

Storage
¾
Clean the machine thoroughly. Chaff and dirt
will attract moisture, which causes corrosion.
¾
Park the machine indoors and secure it with
wheel chocks against rolling away.
¾
Unplug the terminal and store it in a dry place.
¾
Protect the machine against corrosion. Use
only biodegradable oils for anti-rust spraying.
¾
Protect the hydraulic cylinder piston rods
against corrosion.
NOTE
¾
Do not spray the plastic and rubber parts with
oil or corrosion protection agent. These parts
could become brittle and break.
At the end of the season
NOTE
If a high pressure cleaner is used for cleaning,
do not direct the water jet to bearings, electrics/
electronic components and sensitive cover pan-
els. Observe also the section Cleaning with high
pressure cleaner / steam jet .
¾
Clean the filter elements of suction and pres -
sure side.
¾
Lubricate the machine according to the lubri-
cation plan.
¾
Grease the visible threads of setscrews and
similar.
¾
Wet all lever joints and bearing points, which
are not subjected to lubrication, slightly with
oil.
¾
Drain air reservoir.
¾
L ower the height adjustment (optional).
NOTE
Make a note of all service and maintenance
work that has to be done before the start of the
next season and place a corresponding order
with your HORSCH sales partner in due time.
Your HORSCH dealer will be in a much better
position to execute the maintenance service and
possibly necessary repairs outside the season.
Drainage / Water system residue
drain Basic and CCS
Spraying mixture container
1. Switch off all functions.
2. Open the suction filter.
3. Remove the cap on the residue drain / filling
port.
4. Put a suitable collecting vessel under the
drain.
5. Set the suction and pressure valve so that
the spraying mixture container is drained
without residue.
6. Empty the pressure filter via the valve.
7. Turn the open valves to the desired position.
8. Close the port again with the cap!
9. Properly dispose of the collected residual
spraying mixture!
Fresh water tank
1. Remove the cap on the connection for fresh
water filling and open the ball valve.
2. Allow the fresh water to drain.
3. Close the ball valve again and close the port
again with the cap.
4. Drain the hoses on the sensor of the fresh
water tank. Loosen the wide clamp on one
side for this purpose.
288 289