horsch Leeb 5.280 VL, Руководство по эксплуатации

Страница: 121 / 308

Switching on the air conditioner /
heater
¾
Switch on ignition or start engine.
After switching on the ignition, the software ver-
sion is shown in the display (1) for 3 seconds.
1
The device then carries out a self-test, which
takes a maximum of 20 seconds. The buttons
are then enabled for operation.
The operating mode and display after switching
on always correspond to the settings before the
last switch-off.
When the engine stops, the fan speed is reduced
after 10 minutes.
This prevents excessive discharge of the bat-
tery.
NOTE
If the cooling compartment is open, temperature
errors may occur in the climate control system.
¾
Closethe cooling compartment flap again
after opening.
Air conditioning / Heater
The climate control regulates the temperature
and humidity in the cabin.
The following operating modes are available:
•
Automatic temperature and fan control:
Ideal for high outdoor temperatures.
•
Manual fan control:
Automatic temperature control with manual
setting of the fan speed.
•
ECON mode:
Ventilation and heating without cooling func-
tion.
•
REHEAT mode
Dry cabin windows with continuous operation
of the air conditioning compressor at maxi-
mum fan speed.
3 4
5 6 7
8 9
1
2
1 Display to show the desired cabin or outside tempera-
ture. Unit displayed in Celsius or Fahrenheit. In addition,
the error codes for faults are shown on the display.
2 Function light indicates automatic mode.
3 Turn
REHEAT mode on/off.
4 Toggles the display between the cabin temperature and
the outside temperature.
5 Reduce cabin temperature or fan speed.
6 Currently set fan speed (based on a bar chart, max.
speed corresponds to a 100% filled bar).
7 Increase cabin temperature or fan speed.
8 Shift key between manual and automatic fan control.
9 Switching on the ECON mode.
MF 117