GEA Fit R-300, Руководство по эксплуатации и инструкции по установке, Страница: 115 / 168

Programming
Detection parameters
2005-9015-009
01. August 2018
115 / 168
7.7.3 Number of restarts
This parameter is used when a detection occurs. It sets the number of attempts
to resume the cleaning cycle.
When a detection occurs, the control panel stops and backs up the scrapers for
30 seconds. Then, the control panel will try to resume the cleaning cycle.
If the obstacle remains in place, the control panel will detect the obstacle again
and repeat the same process until the number of restarts is reached.
If the obstacle remains detected after having exceeded the number of restarts,
the control panel stops operation and displays the A1 ''OVERLOAD
DETECTED'' alarm.
Note!
The ”NUMBER OF RESTARTS” parameter is active only when the
scrapers have operated for at least 40 seconds since the beginning of
the stroke. When a detection occurs, the scrapers back up for 30
seconds and stop. Then, the control panel switches to the ”NUMBER
OF RESTARTS” mode to complete the cleaning cycle.
Note!
The ”NUMBER OF RESTARTS” parameter resets if the scrapers
operate normally for 60 seconds after having exceeded ”MAX
FLUCTUATION” and the ”DETECTION TIME” or if the scrapers are at
the end of a stroke.
IVR PRO
● Press key until (ParA) appears;
key
● Press key to select;
● Press key until (P03) appears;
● Press key to select;
● Press keys to enter the number of restarts between 0 and 25.
IVR PRO Max@ccess
● Press ”USER”;
● Press ”DETECTION SETTINGS”;
● Press ”NUMBER OF RESTARTS”;
● Use the keypad to enter the number of restarts between 0 and 25.