GE FL000090, Руководство по обслуживанию

Страница: 483 / 740

GE H
EALTHCARE
D
IRECTION
FQ091013, R
EVISION
1 V
IVID
I
N AND
V
IVID Q
N S
ERVICE
M
ANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-131
5.) At any stage, trackball to the
Pause
button and press
Set
, if required.
6.) To resume testing (from the point where you paused), trackball to the
Start
button and press
Set
.
When the Network Test sequence is complete:
- the Diagnostic Test window displays the Finished message
- the View Test Log window opens automatically, listing all tests performed and showing details
of which tests and sub-tests passed or failed, as shown in the example in Figure 7-95 .
Note:
For the Network Test, there is one report which is listed in the Tests window as shown in
Figure 7-95 .
7) When done, trackball to the
Exit
button and press
Set
to close the View Report window.
8) After reviewing the test results, proceed as follows:
• If no problems were identified, it is recommended to re-boot the system (this is obligatory when
prompted).
• If the test passed but the original problem persists, contact your local On-Line Center for
assistance.
• If errors were identified (results exceeding acceptable upper or lower limits), verify that all
system cables and boards are connected (not misplaced) and functioning properly, as
described in
- Components and Function (Theory).
If the problem persists, this indicates that either the specific board you tested is faulty or that
another board that supports the operation of this board is faulty. Continue trouble-shooting
down to the appropriate board. (If necessary, perform a specific test).
If the problem still persists, contact the GE HEALTHCARE On-Line Center for assistance.
9.) Trackball to the
Exit
button and press
Set
to close the View Test Log dialog box.
10.)Press the <
Esc
> button on the keyboard to close the Diagnostic Test Window .
Figure 7-95 View Test Log - Network Test