Foundry FastIron SuperX, Руководство по установке оборудования

Страница: 98 / 198

FastIron Hardware Installation Guide for the FSX, FSX 800, and FSX 1600
5 - 22 © 2008 Foundry Networks, Inc. December 2008
Displaying the Syslog Configuration and Static and Dynamic Buffers
For information about configuring Syslog, see the Foundry FastIron Configuration Guide .
To display the Syslog parameters currently in effect on a system, enter the following command from any level of
the CLI:
Syntax: show logging
The Syslog display shows the following configuration information, in the rows above the log entries themselves.
Static and Dynamic Buffers
The software provides two separate buffers:
• Static – logs power supply failures, fan failures, and temperature warning or shutdown messages
• Dynamic – logs all other message types
Table 5.6: Syslog Buffer Configuration
This Field... Displays...
Syslog logging The state (enabled or disabled) of the Syslog buffer.
messages dropped The number of Syslog messages dropped due to user-configured
filters. By default, the software logs messages for all Syslog levels.
You can disable individual Syslog levels, in which case the software
filters out messages at those levels. Each time the software filters out
a Syslog message, this counter is incremented.
flushes The number of times the Syslog buffer has been cleared by the clear
logging command. For information about clearing the Syslog buffer,
see “Static and Dynamic Buffers” on page 5-22.
overruns The number of times the dynamic log buffer has filled up and been
cleared to hold new entries. For example, if the buffer is set for 100
entries, the 101st entry causes an overrun. After that, the 201st entry
causes a second overrun.
level The message levels that are enabled. Each letter represents a
message type and is identified by the key (level code) below the value.
If you disable logging of a message level, the code for that level is not
listed.
messages logged The total number of messages that have been logged since the
software was loaded.
level code The message levels represented by the one-letter codes.
FastIron> show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 7 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
...