Foundry FastIron SuperX, Руководство по установке оборудования

Страница: 121 / 198

Maintaining the Hardware
December 2008 © 2008 Foundry Networks, Inc. 7 - 7
Figure 7.5 Installing a Switch Fabric Module in the FSX 1600
Replacing an Interface Module
You can remove an interface module and replace it with a new one while the FSX 800 and FSX 1600 chassis is
powered on and running. This also applies to the FSX running software release 02.2.01 or later.
NOTE: The interface modules are interchangeable among all FastIron X Series chassis devices. However, if
you try to install them in a Foundry chassis other than a FastIron X Series, the chassis and interface modules will
not function properly.
This section provides information about the following tasks:
• General precautions
• Removing an interface module
• Installing a new interface module
Precautions
Note the following when removing and replacing Interface modules:
• If you remove an interface module without first disabling it, the chassis will reboot (reload the software).
• You do not need to enable an interface module after inserting it in the chassis. The FastIron X Series chassis
device automatically enables the module when you insert it into a live chassis or when you power on the
chassis.
• You cannot mix IPv4 and IPv6 modules together in the same chassis.
• The software does not allow simultaneous insertion of multiple interface modules. After inserting an interface
S witch F ab ric Mod u le