Foundry FastIron SuperX, Руководство по установке оборудования

Страница: 52 / 198

FastIron Hardware Installation Guide for the FSX, FSX 800, and FSX 1600
3 - 8 © 2008 Foundry Networks, Inc. December 2008
The FSX 800 and FSX 1600 management modules are hot swappable, which means you can remove and insert
them while the chassis is powered on and running. This does not apply to the FSX, which must be powered down
before removing and inserting a management module.
NOTE:
NOTE: The management modules are dedicated, which means that you must install them in the appropriate
chassis. If you attempt to install the FSX management module in the FSX 800, FSX 1600, or other Foundry
chassis, the chassis and module will not function properly. Likewise, if you try to install the FSX 800 or FSX 1600
management module in the FSX or other Foundry chassis, the chassis and module will not function properly.
NOTE: The interface modules are interchangeable among all FastIron X Series chassis devices. However, if
you try to install them in a Foundry chassis other than a FastIron X Series, the chassis and interface modules will
not function properly.
• You cannot mix IPv4 and IPv6 modules together in the same chassis.
Table 3.2 provides the chassis slot numbers into which you must install the modules. The following figures show
the chassis with slot numbers:
• FSX – Figure 2.2 on page 2-5
• FSX 800 – Figure 2.4 on page 2-7
• FSX 1600 – Figure 2.6 on page 2-9
CAUTION: If you do not install a module in a slot, you must leave the slot panel installed in the slot. If you oper-
ate the chassis with an uncovered empty slot, the system will overheat.
Before installing a module in the chassis, have the following on hand:
• An ESD wrist strap with a plug for connection to the ESD connector on the chassis.
WARNING: For safety reasons, the ESD wrist strap should contain a series 1 meg ohm resistor.
• A # Phillips-head or flathead screwdriver.
To install a module in the chassis, do the following:
1. If the FSX chassis is powered ON and you are installing a management module, power down the chassis and
remove the power cables from the chassis power supplies.
NOTE: You do not need to power down the FSX 800 and FSX 1600 chassis when installing a management
module. You can install modules in the FSX 800 and FSX 1600 chassis while it is powered on and running.
2. Put on the ESD wrist strap and ground yourself by inserting the plug into the ESD connector located on the
chassis front.
3. Remove the module from its packaging.
Table 3.2: Module Installation
Module FSX Chassis Slot
Number FSX 800 Chassis Slot
Number FSX 1600 Chassis
Slot Number
Management module 9 9 and 10 9 and 10
Interface modules 1 – 8 1 – 8 1 – 8 and 11 – 18