Foundry FastIron SuperX, Руководство по установке оборудования

Страница: 99 / 198

Managing the Chassis and Modules
December 2008 © 2008 Foundry Networks, Inc. 5 - 23
In the static log, new messages replace older ones, so only the most recent message is displayed. For example,
only the most recent temperature warning message will be present in the log. If multiple temperature warning
messages were sent to the log, the latest one will replace the previous one. The static buffer is not configurable.
The message types that appear in the static buffer do not appear in the dynamic buffer. The dynamic buffer
contains up to the maximum number of messages configured for the buffer (50 by default), then begins removing
the oldest messages (at the bottom of the log) to make room for new ones.
The static and dynamic buffers are both displayed when you display the log.
When you clear log entries, you can selectively clear the static or dynamic buffer, or you can clear both. For
example, to clear only the dynamic buffer, enter the following command at the Privileged EXEC level:
FastIron# clear logging dynamic-buffer
Syntax: clear logging [dynamic-buffer | static-buffer]
You can specify the dynamic-buffer keyword to clear the dynamic buffer or the static-buffer keyword to clear the
static buffer. If you do not specify a buffer, both buffers are cleared.
Syntax: show log
Syslog Messages for PCI (Hardware) Errors
FastIron Chassis devices running software release 04.2.00 and later support the display of PCI (hardware) read
and write errors encountered on a slot/module during bootup and during normal system operations. There are
four types of PCI errors, which may cause the system to disable/power down the module(s) on which they occur:
• Configuration read error
• Configuration write error
• Memory read error
• Memory write error
For more information, see the “Using Syslog” chapter in the Foundry FastIron Configuration Guide .
Managing the Switch Fabric Modules (FSX 800 and FSX 1600 Only)
If desired, you can disable power to a switch fabric module and then reenable it. To disable the power, enter the
following command at the Privileged EXEC level of the CLI:
FastIron# disable switch-fabric 1
FastIron(config)# show logging
...
Static Log Buffer:
Aug 27 12:42:42:A:Power Supply 6, 1st right, failed
Dynamic Log Buffer (50 lines):
Aug 27 12:19:04:I:Interface ethernet3/4, state up
Aug 27 12:19:04:I:Interface ethernet6/3, state up
Aug 27 12:19:04:I:Interface ethernet3/2, state up
Aug 27 12:19:04:I:Interface ethernet6/1, state up
Aug 27 12:19:00:N:Module up in slot 6
Aug 27 12:19:00:N:Module up in slot 3
Aug 27 12:18:43:I:Warm start