Chapter 3 Entering softpatch and system settings
23
Setting default full level
The default full setting is the level the
PSC enters for selected channels when
you press [Full]
. [Full] is set originally at 100 percent, and is reset to 100 percent
after a diagnostic system clear.
When you set the default full level below 100 percent, you can still set channels
above the [Full] level setting by using [At], [+], [-], or the level control strip
. To set
[Full] at a level other than 100 percent, follow these steps:
1.
Press [Set Up]
.
2.
Select 6,
System Settings
, and press [Enter].
3.
Select 1,
Default Full Level
, and press [Enter].
4.
Either enter a two-digit intensity level, or press [Full] to set level at 100
percent.
Note: When you set dimmer levels on the softpatch screen, [Full] enters
100 percent regardless of the default full level setting.
Setting default up and down fade times
The
PSC automatically enters default up and down fade times unless you
specifically change them
. A diagnostic system clear resets the defaults to five
seconds
. To customize default fade times, follow these steps:
1.
Press [Set Up].
2.
Select 6,
System Settings
, and press [Enter].
3.
Select 2,
Default Up/Down Times
, and press [Enter].
4.
Enter upfade time in minutes and seconds (00:00) or in seconds and
frames (00.00), then press [Enter]
. Upfade times can be from 00.01 (one
frame) to 99:59 (99 minutes; 59 seconds).
Note: Enter a decimal point between seconds and frames. (One second
equals thirty frames.)
5.
Enter downfade time in minutes and seconds (00:00) or in seconds and
frames (00.00), then press [Enter]
. Like upfade waits, downfade times can
be from 00.01 (one frame) to 99:59 (99 minutes; 59 seconds).
