ENSONIQ MR Rack, Руководство музыканта

Страница: 246 / 314

Chapter 9 —Supplemental Information
16 ENSONIQ MR-Rack Musician’s Manual
Res et Al l Cont rol l er s ( MI DI con t rol l er 121) Recep t i on Be havi or
W hen the System page, R esetCont r ol R ecv=O ff , the R eset A ll Cont r olle r s message will be
igno r ed.
W hen System page, R esetCont r ol R ecv=On, the f ollowing M I D I messages and pa r amete r s on
all pa r ts assigned to the M I D I channel on which the message was r eceived will be r eset to
the f ollowing values :
Assignable SysCtrl1-4=000 Controller 008=064 Controller 070 to 071=000
Pitch Bend=center Controller 009=000 Controller 072 to 079=064
Channel Pressure=000 Controller 010=064 Controllers 080 to 097=000
Polyphonic Pressure=000 for all 88 keys Controller 011=127 Controller 098 to 101=cleared
Controllers 001 to 004=000 Controllers 012 to 031=000 Controllers 102 to 119=000
Controller 005=064 Controllers 033 to 064=000 Controllers 120 to 127=left unchanged
Controller 006=000 Controller 065=000
Controller 007=100 Controllers 066 to 069=000
When System page, Part Param Reset=Off:
Cont r olle r s 005, and 070 to 079 will be le f t unchanged.
When System page, Part Param Reset=On:
Cont r olle r s 005, and 070 to 079 will be r eset to the values listed above.
Pa r t M I D I r eception f ilte r s do not a ff ect r eception o f the R eset A ll Cont r olle r s message.
Registered Parameters
R egiste r ed pa r amete r s 0, 1 and 2 a r e r eceived multi-timb r ally by the M R - R ack. W hen
r eceived on a Pa r t ’ s M I D I channel, R PN 0 a ff ects the Pa r t ’ s Pitch Bend Up and Down
simultaneously : Pitch Bend up is r aised and Pitch Bend Down is lowe r ed by the same R PN
value. R PNs 1 and 2 edit Semitone Shi f t and Fine T uning pa r amete r s, r espectively, when
r eceived on the Pa r t ’ s M I D I channel.
R egiste r ed pa r amete r s must be t r ansmitted to the M R - R ack as a Continuous Cont r olle r
status byte f ollowed by th r ee consecutive Continuous Cont r olle r messages : T he R egiste r ed
pa r amete r M SB and L SB values select the Pa r t pa r amete r that will be edited, and a Data
Ent r y value invokes the Pa r t pa r amete r ’ s desi r ed setting.
Controllers
Number
Name Value
101 Registered Parameter Select MSB (Most Significant Byte) always 0
100 Registered Parameter Select LSB (Least Significant Byte) 00, 01 or 02 (see below)
6 Data Entry MSB 0-127, desired Part parameter setting
Registered Parameters
Number
Name MR-Rack Parameter Range
00 Pitch Bend Range 0-12 (displayed as Pitch Bend Up =0-12 up raises pitch Pitch Bend
Down=0-12 down
01 Fine Tuning 0-127 (displayed as -50 cents to +49 cents)
02 Coarse Tuning 0-127 (displayed as -64st to +63st)