Chapter 8
—Insert Effect Parameters
To access the Parameters described on this page (unless otherwise noted):
Press Effects
,
turn the Parameter knob to select Insert Effect
,
and press Enter
.
Turn the Parameter
knob to select the parameter
,
and use the Value knob to change the parameter's Setting
.
ENSONIQ MR-Rack Musician’s Manual
11
LFO Phase
-180deg to +180deg
Controls the relative phase between left & right LFOs.
Chorus Depth
0.0ms to 25.0ms
Controls the amount of modulation.
Chorus Center
0.0ms to 50.0ms
Controls the delay times within the chorus. Adjusting this parameter will
change the tonal character of the chorus.
System Feedback
-99% to +99%
Controls the amount of feedback applied from the output of the chorus to
the input of the reverb.
13 Rev
→
Flanger
Flanger Mix
Output
L
R
Flanger
Right
Left
Reverb
System Feedback
T
his
I
nse
r
t E
ff
ect
f
eatu
r
es a plate
r
eve
r
b with a
f
lange
r
e
ff
ect.
Parameter
Range
Description
Decay
0.0sec to 10.0sec
Controls the amount of time it takes for the reverb to decay after the input
signal stops.
HF Damping
100Hz to 21.2kHz
Controls the rate of attenuation of high frequencies in the decay of the
reverberation. Increasing the value of this parameter will gradually filter
out (dampen) more and more high frequency energy.
HF Bandwidth
100Hz to 21.2kHz
The high frequency bandwidth acts as a low pass filter on the signal
going into the reverb, controlling the amount of high frequencies that will
pass into the effect. The higher the setting, the more high frequencies are
allowed to pass.
Diffusion 1
0 to 100
Smears the input signal transients, to diffuse and smooth the sound.
Lower values will cause impulse sounds to appear as a series of discrete
echoes, while higher values tend to increase the smear (smoother
sounding with fewer discrete echoes). We recommend settings of 50 for
starters.
Diffusion 2
0 to 100
This parameter, similar to and in series with Diffusion1, performs the
same way but controls lower frequency ranges. Experiment with different
levels between the diffusion parameters to find the settings that are right
for your source.
Definition
0 to 100
Controls the rate at which echo density is increased with time. Setting
this parameter too high can cause the echo density to build at a rate which
exceeds the decay rate.
FlangerMix
Full Dry to Full Wet
Controls the Dry/Wet mix of the flanger.
LFO Rate
1/1 Sys to 1/32 Sys, 0.0Hz
to 20.0Hz
Controls the rate of modulation applied to the flanger.
LFO Shape
Triangle, Sine, Sawtooth,
Square, Asym, Step
Determines the shape that the LFO will use for pitch modulation.
LFO Phase
-180deg to +180deg
Controls the relative phase between left and right LFOs.
Flanger Depth
0.0ms to 25.0ms
Controls the range of the high-to-low frequency sweep in the flanger
effect.
FlangerCenter
0.0ms to 50.0ms
Sets the sweep mid-point of the flanger effect.
Notch Depth
0% to 100%
Controls the depth of the peaks and notches produced by the flanger.
Feedback
-99% to +99%
Controls the amount of feedback applied to the flanger. Positive or
negative values will impart a different tonality to the flange effect, either
accenting the peaks or the notches.
System Feedback
-99% to +99%
Controls the amount of feedback applied from the output of the flanger to
the input of the reverb.
