84
InStallatIon anD oPeratIon manual
25-15049-G
October 2021 www.eaton.com
12. Commissioning
12.10 Common Setups
12.10.1 Default - Any Input Triggers All Outputs
To create a very basic setup in which all inputs trigger all outputs, you can create a
single source and destination matrix.
1. Create a new matrix.
2. Add Network - Any/All to the sources.
3. Add Network - Any/All to the destinations.
4. Bind that source to that destination (there will only be one cell
in the matrix).
12.10.2 Some Alarm Zones only being Triggered by some Detection Zones.
If you want some alarm zones to only be triggered by detection zones, then you will
need to configure each alarm zone individually. This can still be done with a
single matrix.
1. Create a new matrix.
2. Add Network - Any/All to the sources.
3. Add any Detection Zones to the sources that will be used for specific Alarm
Zone activations.
4. Add each individual Alarm Zone to the destinations.
5. For all the Alarm Zones that will activate from any source, create a binding
between Network - Any/All and each appropriate Alarm Zone.
6. For the each of the other Alarm Zones, bind only the Detection Zones that
should activate it.