Docomo FOMA D901i, Руководство пользователя, Страница: 509 / 596

507
Data Co
mm
unic
a
tio
n
ATS10= [n] Specifies the permissible delay time before automatic disconnection. This command sets the register
but no action will occur.
n=1 to 255: in 1/10 seconds. (1: default and when parameter omitted)
*1, *2 ex. Enter ATS10=1 Display ATS10? Test None
ATS30= [n] Specifies the time elapsed after the last data transmission to activate automatic disconnection. This
command is effective for 64K data communication.
n=1 to 255: 1 to 255 minutes. n=0: Does not disconnect. (default and when parameter omitted)
*1 ex. Enter ATS30=0 Display ATS30? Test None
ATS103= [n] Specifies a mark to be used to delimit a destination subaddress if attached. This command is
effective for 64K data communication.
n=0: ＊ ( when parameter omitted) n=1: / (default) n=2: ￥
*1 ex. Enter ATS103=0 Display ATS103? Test None
ATS104= [n] Specifies a mark to be used to delimit a caller subaddress if attached. This command is effective for
64K data communication.
n=0: # (when parameter omitted) n=1: % (default) n=2: &
*1 ex. Enter ATS104=0 Display ATS104? Test None
AT
￥
S
Shows the command settings and the contents of the S register.
ex. Enter AT ￥ S Display None Test None
AT ￥ V [n]
Specifies whether to use the extended result code for connection.
☛
P509
This command takes effect when the ATX command parameter is n=1 to 4.
n=0: Does not use the extended result code. (default and when parameter omitted)
n=1: Uses the extended result code.
*1, *2 ex. Enter AT ￥ V0 Display None Test None
Command Description & Parameter
Disconnection reason list
■
Packet communication
■
64K data communication
Error messages list
Value Reason
27 APN is not present or is incorrect.
30 Disconnected by network.
33 Terminal does not subscribe to packet
communication.
36 Normal disconnection.
Value Reason
1 Specified number does not exist.
16 Normal disconnection.
17 Communication is impossible because remote
device is busy.
18 You made a call but did not receive a response
within the specified time.
19 Communication is impossible because the
remote device is busy calling.
21 The remote device rejected incoming calls.
63 The service and option of the network are not
valid.
65 Unavailable processing speed was specified.
88 You made a call to a terminal or received a call
from a terminal with different terminal
properties.
No.
Text
display
Reason
10 SIM not
inserted No UIM (FOMA card) is set
15 SIM
wrong Other than DoCoMo SIM (IC
card equivalent to UIM) is
inserted
16 incorrect
password Incorrect password
100 unknown Unknown error