4
|
Components
Service manual
118
EBLA04~08E + EDLA04~08E
Daikin Altherma 3 M
ESIE22-09 – 2022.05
CAUTION
Do NOT connect the Megger ground test lead to any other ground wire.
4
Measure the insulation resistance between the following terminals. The
measured insulation resistance MUST be >3 MΩ.
Terminals
K1M1‑ground
K1M3‑ground
Is the measured backup heater
insulation resistance correct?
Action
Yes
heater and continue with the next
procedure.
No
Replace the backup heater, see
To perform an electrical check of the backup heater
Prerequisite:
First perform an insulation check of the backup heater, see
Prerequisite:
Check the circuit breaker. Reset if it has tripped.
Prerequisite:
Check that the backup heater thermal protector functions correctly.
Reset if it has tripped. See
"4.4 Backup heater thermal protector"
1
Turn ON the power of the unit.
INFORMATION
If the circuit breaker or the backup heater thermal protector trips again, determine
the root cause of the problem. Something is overloading the electrical circuit or
creating a short-circuit.
2
Activate
Installer
on the user interface. See the installer reference guide
for the correct procedure.
3
Go to
Actuator test run
via the user interface.
4
Activate backup heater: step 1.
5
Check the status in the Actuators menu of the user interface. This MUST be:
▪
Backup heater: step 1 = ON
6
Check if the field installed circuit breaker has tripped.
Did the fuse blow or did the field
supplied circuit breaker of the backup
heater trip?
Action
Yes
Replace the backup heater, see
No
heater and continue with the next
procedure.
draft – 31/05/2022 15:53
Содержание EBLA04E V Series
Страница 322: ...14 14...
Страница 323: ......
Страница 324: ...draft 31 05 2022 15 53 ESIE22 09 2022 05 Copyright 2022 Daikin Verantwortung f r Energie und Umwelt...