3A Setup Information
CPI Canada Inc.
Page 3A-2 Rev. A Millenia / Indico 100 Series Service Manual Ch # 740904-04
3A.1.0 INTRODUCTION
Please record the setup information for your installation in this section before programming the generator. Enter
the information appropriate for your generator model. The data tables will accommodate installations up to a
standard R&F installation with the following: tilting G.I. table with bucky, spot film device, standard image tube
with a medical T.V. system, wall bucky and an overhead tube stand, spot film camera and a digital acquisition
system.
3A.2.0 INSTALLATION RECORD
3A.2.1 X-Ray Tubes
Please enter the appropriate information.
a)
Over table X-ray tube (or TUBE # 1)
b) Manufacturer
and
type:
c)
Focal spot combination:
large =
small =
d)
kW of each focal spot:
large =
small =
e) Maximum
kVp:
f) Type
of
stator:
g) Dual
or
single
speed:
h) Stator
delay:
sec
=
i)
Start and run voltage, low speed:
start volts =
run volts =
j)
Start and run voltage, high speed:
start volts =
run volts =
k) Brake
voltage:
volts
=
l)
Maximum filament current:
amps =
m)
Minimum filament current, stand-by:
amps =
n) Thermal
switch
included:
o)
Under table X-ray tube (or TUBE # 2)
p) Manufacturer
and
type:
q)
Focal spot combination:
large =
small =
r)
kW of each focal spot:
large =
small =
s) Maximum
kVp:
t) Type
of
stator:
u) Dual
or
single
speed:
v) Stator
delay:
sec
=
w)
Start and run voltage, low speed:
start volts =
run volts =
x)
Start and run voltage, high speed:
start volts =
run volts =
y) Brake
voltage:
volts
=
z)
Maximum filament current:
amps =
aa)
Minimum filament current, stand-by:
amps =
bb) Thermal
switch
included:
cc)
X-ray tube fan included: