CPI Canada Inc
Regular Maintenance
6
Millenia / Indico 100 Series Service Manual Ch # 740904-10 Rev. D
Page 6-5
6.4.2
Indico 100 Oil Fill/Level Check
1.
Loosen the oil fill plug screw on the Indico 100 tank lid.
2.
With the screw sufficiently loosened, remove the rubber (neoprene) plug.
3. Use
a
clean ruler, strip of cardboard, or other equivalent material to determine the oil level --
measured always from the TOP surface of the HT tank’s lid.
•
Normally the oil level should be between 0.5 -0.9 inches (13 - 23 mm) from the top of the tank lid.
•
If the oil level is between 0.9 - 1.3 inches (23 - 33 mm) from the top of the tank lid, then clean oil
should be added as needed.
•
If the oil level is greater than 1.3 inches (33 mm) below the top of the tank lid, please consult the
factory.
Figure
6-2:
HT
tank
oil
level
4.
Use only fresh oil, type Shell DIALA AX or equivalent. If a funnel is used to add the oil, take care not to
damage any of the delicate components inside the tank.
5.
Replace the oil fill plug. Once the plug is installed and the screw properly seated, tighten the screw 4
turns. This will secure the oil fill plug. Wipe up any oil spills. Dispose of soiled absorber in compliance
with government requirements and ensure conformity to local disposal regulations. THE OIL DOES
NOT CONTAIN PCBs
