Administration: File Management
Firmware Operations
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
80
6
-
Password
—Enter a password for this copy.
NOTE
The username and password for one-time credential will not saved in
configuration file.
STEP 6
Enter the following fields:
•
Server Definition
—Select whether to specify the SCP server by IP address
or by domain name.
If Server Definition is
By Address
:
-
IP Version
—Select whether an IPv4 or an IPv6 address is used.
-
IPv6 Address Type
—Select the IPv6 address type (if used). The options
are:
Link Local
—The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of
FE80
, is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
Global
—The IPv6 address is a global Unicast IPv6 type that is visible and
reachable from other networks.
-
Link Local Interface
—Select the link local interface from the list.
•
Server IP Address/Name
—Enter the IP address or domain name of the
SCP server, whichever is relevant.
•
(Update) Source File Name
—Enter the name of the source file.
•
(Backup) Destination File Name
—Enter the name of the backup file.
STEP 7
Click
Apply
. If the files, passwords and server addresses are correct, one of the
following may happen:
•
If SSH server authentication is enabled (in the SSH Server Authentication
page), and the SCP server is trusted, the operation succeeds. If the SCP
server is not trusted, the operation fails and an error is displayed.
•
If SSH server authentication is not enabled, the operation succeeds for any
SCP server.
