VLAN Management
Regular VLANs
Cisco 350XG & 550XG Series 10G Stackable Managed Switches
236
12
•
PVID
—Select to set the PVID of the interface to the VID of the VLAN. PVID is
a per-port setting.
STEP 4
Click
Apply
. The interfaces are assigned to the VLAN
, and
written to the Running
Configuration file.
You can continue to display and/or configure port membership of another VLAN
by selecting another VLAN ID.
Port VLAN Membership
The Port VLAN Membership page displays all ports on the device along with a list
of VLANs to which each port belongs.
If the port-based authentication method for an interface is 802.1x and the
Administrative Port Control is Auto, then:
•
Until the port is authenticated, it is excluded from all VLANs, except guest
and unauthenticated ones. In the VLAN to Port page, the port is marked with
an upper case P.
•
When the port is authenticated, it receives membership in the VLAN in
which it was configured.
NOTE
VLAN IS mode is supported. This means that port VLAN membership can be
configured ahead of time for various VLAN modes. When the port is put into the
specific VLAN mode, the configuration becomes active.
To assign a port to one or more VLANs:
STEP 1
Click
VLAN Management
>
Port VLAN Membership
.
STEP 2
Select interface type (Port or LAG), and click
Go
. The following fields are
displayed for all interfaces of the selected type:
•
Interface
—Port/LAG ID.
•
Mode
—Interface VLAN mode that was selected in the
page.
•
Administrative VLANs
—Drop-down list that displays all VLANs of which
the interface might be a member.
•
Operational VLANs
—Drop-down list that displays all VLANs of which the
interface is currently a member.
