Bull NovaScale R440 E1, Руководство пользователя, Страница: 61 / 366

User Guide
60
www.bull.com
In such a case, press F1 to continue POST. Board configuration
can be made using the utility described later.
1. After a few seconds from power-on, POST starts checking the memory. The
count message of the basic and expansion memory appears at top left on the
display unit screen. The memory check may takes a few minutes to complete
depending on the memory size of the server. Also, it may take approximately
one minute for the screen display to appear after rebooting the server.
2. Some messages appear upon completion of the memory check. These
messages appear to indicate that the system has detected the CPU, baseboard
management controller, keyboard, and mouse.
3. After a few seconds, POST displays the following message prompting you to
launch the BIOS SETUP utility stored in the system memory of the server.
This message appears at bottom left on the screen.
Launch the BIOS setup utility when you need to change the settings to meet the
requirements for the server. As long as the above message is not displayed with
an error message, you don't have to launch the utility. (Ignore the message.
POST will automatically proceed.)
To launch the SETUP utility, press F2 while the above message is displayed.
See Chapter 4 for setup and parameters.
The server automatically restarts POST all over again when you exit the
SETUP utility.
The message "<F12> to Network" prompts you network booting (PXE boot). If
you press
F12 , the POST searches for boot device on network.
4. When 3.5-inch disk model server contains 3.5-inch SATA hard disk drive>
If your server uses Onboard RAID Controller, the following message is
displayed to prompt you to run RAID utility.
Press Ctrl + M to run the utility. For detail explanation, see Chapter 4 for
detail.
Caution
The LSI Software RAID Configuration Utility is used to manage
the data stored in hard disk drive, or for maintenance. See
Chapter 4 for detail. This feature is unavailable for 2.5-inch disk
model.
Press <F2> to enter SETUP, <F12> to Network
Press <Ctrl><M> to Run LSI SoftwareRAID Configuration Utility