Bull NovaScale R440 E1, Руководство пользователя, Страница: 200 / 366

User Guide
199
www.bull.com
Notes: Observe the following notes on installing/removing
a PCI board:
■
Do not touch the terminals of the riser cards and the leads of
electronic components with your bare hand. Fingerprints and
dust left on them cause the server to malfunction due to a
connection failure or damage to the leads.
■
A riser card is designed for installing only low-profile PCI
boards or full-height PCI boards. Before installing a PCI
board, make sure of the card specification.
■
The system detects the boot devices in order of the PCI bus
slots 1B (full-height PCI board) and then 1C (low-profile PCI
board).
■
The PCI devices of the same type (including onboard PCI
device) may be recognized in different order from that
described above, depending on the OS or the RAID system
utility. Check the slot location of PCI device by PCI bus num-
ber, device number and function number shown in the table
below.
■
Set "Disabled" for the optional ROM of a LAN device not to
be booted by using the BIOS SETUP utility.
■
If an additional LAN device is installed, it is hard to push the
catch of the connector with your finger that is connected to
the LAN port. Disconnect the connector pushing the catch
with a standard screwdriver. At this time, be very careful for
the screwdriver not to damage the LAN port or other ports.
■
If a bootable PCI board (e.g., a RAID controller, SCSI con-
troller, or LAN card) is additionally installed, the boot priority
is changed. After the additional installation, start the BIOS
SETUP utility, select [Boot] and set the new boot priority.
■
Contact your service representative for the acceptable
optional PCI board.
Bus number Device
number Function
number
Onboard NIC1 C 0 0
Onboard NIC2 C 0 1
Slot 1C 18 0 X
Slot 1B 3 0 X
* On certain PCI devices, other bus numbers may be assigned.