Bull NovaScale R440 E1, Руководство пользователя, Страница: 204 / 366

User Guide
203
www.bull.com
8. Insert the riser card assembly into the slot on the motherboard.
Align the riser card terminal section with the slot on the motherboard, and
firmly push the riser card until it is fully seated.
Notes:
■
There are catches on the riser card frame that are used to
secure the riser card to the cabinet. When inserting the riser
card, confirm that the catches are correctly fit into the holes
on the rear of the cabinet. After the insertion, push the riser
card with your fingers until you cannot see any part of the
riser card terminal section. The riser card is now fully seated
in the slot.
■
Pay attention not to damage the components on the mother-
board with the riser card when inserting it into the slot.
Figure 142: Inserting the Riser Card Assembly into the Motherboard
9. Install the components you removed previously.
10. Verify that POST displays no error messages.
11. If POST displays an error message, take a note on the message and see the
POST error messages listed in “POST Error Messages” on page 241 .
12. Run the BIOS SETUP utility and select "Yes" for [Advanced] ® [Reset
Configuration Data].
This setting is required to change the hardware configuration data. See
“BIOS
Setup Utility” on page 63 for details.
Removing a PCI Board
Remove a PCI board in reverse order of the installation steps.