Brunswick GS-X Series, Руководство по эксплуатации и обслуживанию

Страница: 254 / 302

7-8 Section 7: Preventative Maintenance
Section Rev. February 2009
Drive Frame Assembly
1. Inspect the welds and condition of the sweep shaft. Check the sweep shaft supports for secure
mounting. Inspect the sweep shaft bearings for signs of wear. Inspect the connecting rods and
verify all hardware is in place and secure.
2. Inspect the condition and welds on the left-hand and right-hand drive frame assemblies. Check
for loose or missing hardware. Inspect all cable channels and cables for condition and routing.
Check for any worn shaft bearings. Check the chain tensioners for condition and adjustment.
Inspect the frame counter for correct operation.
3. Inspect the spotting tong drive for loose or missing hardware. Check for loose or worn gears.
Check the spotting tong solenoid for proper operation. Check the spotting tong clutch for
correct operation, and check the condition of the clutch shaft. Inspect the mesh between the
square shaft drive gear and the spur gear. Check the condition of the square shaft drive gear.
4. Inspect the motors for correct mounting and alignment. Check the condition of all V-belts.
Inspect the motor cables for correct routing. Check the condition of the motor tensioning
springs. Check all motor mounting plate bushings. Check for excessive vibration in motor and
belt operation.
5. Inspect the stroke limiter for a bent or cracked plate and loose or missing hardware. Check
the mounting of the stroke limiter shock absorber. Check the condition of the rubber bumper.
Check the solenoid for proper operation. Inspect the square shaft, the linkage and the square
shaft latch for correct adjustment.
6. Inspect the condition of the double V-belts. Check for loose or missing tensioner mounting
hardware. Check the tensioner shaft and bearings for loose or noisy operation.
7. Inspect the condition of the setting table and sweep motor drive assemblies. Check for worn or
damaged chains. Check for loose or missing bearing plate hardware. Inspect the condition of
bearing plate bearings and drive sprocket shafts.
8. Inspect the condition of the guide tower assembly. Check the mounting and adjustment on the
TS-2 and OOR switch. Check for correct switch cable mounting. Check for loose or missing
guide tower hardware. Inspect the condition of the lift chain sprocket. Check the condition of
the jam lever and spring.
9. Inspect the sweep and table drive shaft assemblies. Check for shaft wear. Check for chain wear
and proper tensioning. Inspect the crank arms and verify they are secure on the shafts. Check
the sprockets for wear.
10. Inspect the switch cluster. Check the switch cluster housing to make sure it is secure. Check
the adjustment on the “A,” “B,” “C,” and “D” switches. Check the adjustment on the switch
cam.