Bosch SOLUTION 6000, Руководство по установке

Страница: 129 / 172

Solution 6000

Installation Manual

Device Programming
10-5
Bosch Security Systems 07/14 BLCC610I
To Change Area option. Setting this option will set
the system to request a user’s PIN before allowing
them to view another area. The system will only
allow a user to view the areas they have access to.
See MENU 6-1-4 — Keypad General Options.
4) Press [MENU] + [6] + [1] + [3] and use the up and
down arrows to highlight the keypad in the list
then press [OK]. Use the up and down arrow keys
to select the Home Area required then press [OK] to
save and exit or press [MENU] to exit without
saving.
Home Area Kp1
01 - Security System
Press

0-9 OK to SAVE
i
Note
Each keypad must be set to a unique address via the
DIP switches on the keypad and each keypad must
have a home area programmed to operate correctly.
Area 1 is the default home area for all keypads.
Devices > Keypads & Readers >
General Options

MENU 6-1-4
1 Enable Rear Tamper N
2
Report Temperature
Y
3 Installer PIN Allowed Y
4 Show Alarm When Armed Y
5 Reader Area Control Y
6
Reader Badging
N
7 Enable Egress Input N
8 Log Egress Events N
The above options can be configured independantly for
each keypad fitted to the system.
1) Press [MENU] + [6] + [1] + [4] and use the up and
down arrows to highlight the keypad in the list
then press [OK].
Enable Rear Tamper
Report Temperature

Installer PIN Allowed
Press

OK ON OFF MENU
2) Use the up and down arrow keys to highlight the
option then press the [ON] key to enable or the
[OFF] key to disable.
3) Repeat Step 2 until all options are programmed as
required, then press [OK] to save and exit or press
[MENU] to exit without saving.
Enable Rear Tamper
This option allows the tamper circuit located on the back
of the LAN device to function. As soon as the LAN device
has been removed from the wall, the control panel will
register an alarm event..
For this option to work, the keypad model being used
must have the on-board tamper switch fitted.
Report Temperature
This option allows the control panel to report
temperature high and low alarm reports when the
temperature at the LAN device falls below or increases
outside the global temperature settings in MENU 7-7-3.
Installer Allowed
This option allows the installer to access to the the
system menus or to turn the aea (or system) on or off at
LAN device.
Show Alarm When Armed
This option allows the keypad to display which zone
registered an alarm. If multiple zones have registered an
alarm, the keypad will scroll each zone one at a time.
If the option is programmed, the keypad will display as
below:
Security System
ALARM
Alarm Zone 1 Name
If the option is not programmed, the keypad will display
as below:
Security System
ALARM
Sat 06-Jan-2012 7:03pm
Reader Area Control
This option allows the user to control the alarm area as
well as access at the same time. Turning this option off
would make the console a pure access only device.
Reader Badging
This option allows the user to unlock a door (via Doors)
and also turn on or off an area from the same LAN reader
independently.
No Badging Badging Required
Area Is All On
Swipe Token Once
Open Door +
Disarm Area Open Door +
Disarm Area
Area Is Off
Swipe Token Once
Open Door +
Turn Area All On
Open Door