Belden GRASS VALLEY KALEIDO-MX 1RU, Инструкция по установке и обслуживанию

Страница: 61 / 164

61
Kaleido-MX (1RU)
Installation & Service Manual
The selected link mode is applied.
13 Press ESC to return to the previous level in the local control menu.
LINK MODE EDIT appears again on the LCD display.
14 Press the [–] button.
OUTPUT A IP EDIT appears on the control panel’s display.
15 Repeat step 3 and step 4 to configure the IP address for Output A.
16 Once you have set the IP address for Output A, and navigated back to the previous
menu level, press the [–] button again.
OUTPUT B IP EDIT appears on the control panel’s display.
17 Repeat step 3 and step 4 to configure the IP address for Output B.
18 Once you have set the IP address for Output B, press the Select button on the front edge
of the output card to exit the control menu.
After a moment, both output cards restart. The startup sequence takes approximately
four minutes, during which time the cards’ Status LEDs are first red and then flashing
orange.
19 Once the startup has completed, check both cards’ Status LEDs again, and make sure
that they do not indicate an error condition. See Output card Status LED , on page 32.
Should a Status LED indicate an error condition, see Output card Status LED , on page 32
to find out what the other LEDs might be indicating.
20 Verify that both cards’ and the system’s new IP addresses are effective, by referring to
Verifying the Multiviewer’s IP Addresses and Application Version , on page 129.
Notes
• If you do not press any button on the Densité frame local control panel, the
Densité controller will revert to its normal standby mode, and the selected
card's Status LED will revert to its normal operating mode, after 30
seconds.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not press the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had pressed the SEL button.