119
Kaleido-MX (1RU)
Installation & Service Manual
• If not, PoE mid-span (
inserter
) equipment must be placed between the switch and
the Audio Bridge Terminal.
4 Press the RESET button (located on the right-hand side of the ABT rear panel beside the
ETHERNET/POWER RJ-45 connector) for at least 1 second.
The Audio Bridge Terminal will reboot with the following static network configuration:
5 Using a Web browser on the PC, connect to the ABT using the following address:
10.0.3.190.
The home page of the ABT’s built-in Web server is displayed.
6 Click
Network Configuration
(in the navigation pane).
The
Network Configuration
page is displayed.
7 Change the ABT’s network settings, as necessary, and then click
Apply & Reboot
.
For more information about the ABT, refer to the
Audio Bridge Terminal Guide to Installation
and Operation;
Configuring a PC to Configure an ABT’s Network Settings
The PC that you will use to communicate with the ABT must have an IP addresses within the
same subnet. The following procedure applies to a typical Windows 10, Windows 8, or
Windows 7 system.
Property
Setting
DHCP
OFF
Static IP address
10.0.3.190
Subnet mask
255.255.0.0
Default gateway
10.0.0.1
Notes
• The Kaleido-MX (1RU) supports one ABT device.
• Keep in mind that all ABTs ship with the same default static IP address. If
you are adding more than one ABT to your network and do not use DHCP,
make sure to assign each ABT a different static IP address before
connecting them to the network.
