Belden GRASS VALLEY KALEIDO-MX 1RU, Инструкция по установке и обслуживанию

Страница: 55 / 164

55
Kaleido-MX (1RU)
Installation & Service Manual
Kaleido-MX housing frames are shipped with their CPU-ETH2 controller configured with
the following default settings:
To set the system name and IP addresses for your Kaleido-MX multiviewer
1 Configure the Densité CPU-ETH2 controller with an appropriate IP address (see Setting
a Densité CPU-ETH2 Controller’s IP Address , on page 57).
2 Verify that the Densité CPU-ETH2 controller’s automatic restore feature is enabled (see
Enabling the CPU-ETH2 Automatic Restore Feature , on page 50).
3 Configure your output cards’ networking parameters:
• If you have a quad-head Kaleido-MX, replace the system IP address, network mask,
default gateway, and both output cards’ IP addresses as appropriate. See
Configuring the Network Settings for a Quad-Head Kaleido-MX on page 60.
The system IP address will be your system’s virtual IP address. This is the address
you will use to access your system from XEdit and XAdmin, for example.
• If you have a single-head or a dual-head Kaleido-MX, then replace the IP address
for Output A with an appropriate IP address, and change the network mask and
default gateway as appropriate. See
Configuring the Network Settings for a Single-
or Dual-Head Kaleido-MX on page 58.
The output card’s IP address will automatically become your system’s virtual
IP address.
4 Configure the Kaleido-RCP2, and Audio Bridge Terminal units you have connected to
your system, if any. See Configuring the Kaleido-RCP2 on page 115, and Configuring an
Audio Bridge Terminal , on page 118.
Output A IP address 192.168.3.31 192.168.3.31
Output B IP address 0.0.0.0 192.168.3.32
Note:
The default gateway address is either 0.0.0.0, or the default system IP
address. Both settings result in the same system behavior.
Densité CPU-ETH2 controller default IP settings
IP address 1 192.168.3.1
Network mask 255.255.255.0
Gateway 0.0.0.0
IP address 2 0.0.0.0
Network mask 0.0.0.0
Gateway 0.0.0.0
Note:
For the card hot swap feature to function properly, the CPU-ETH2
automatic restore feature must be activated.
Kaleido-MX default IP settings (continued)
Dual Quad