114
System Configuration
Correlating Monitor Wall Destinations and KX Router Logical Routers for the RCP-200
Correlating Monitor Wall Destinations and KX Router Logical Routers for the
RCP-200
To operate the monitor wall from the RCP-200’s category/index router view, your system
must have been configured to be controlled as a router. In a layout, the RCP-200 can only
control monitors that have been assigned a monitor wall destination. The first time you log
on to a room from the RCP-200, you will be prompted to select a router from the left-hand
screen. By selecting the appropriate KX Router logical router, you will establish the
correlation between your multiviewer’s monitor wall destinations and the RCP-200’s
representation of the multiviewer’s
KX Router
logical router. In the case of a cluster system,
you will also be prompted to select a router, the first time to try to assign a source to a
monitor located in a part of the layout that belongs to a different member of the cluster.
You only need to do this once, for every multiviewer that is part of a cluster.
To correlate a monitor wall destination in a layout and the corresponding KX Router
logical router
1 In the list on the left-hand screen, touch the
KX Router
logical router associated with the
multiviewer whose name was indicated in the message prompting to select a router
(you can see the multiviewer name, its IP address, and the size of that particular KX
Router).
2 Touch the Video level, in the area to the right of the router list, if it is not selected
already, and then push SELECT.
The RCP-200 will remember the association with the KX Router logical router’s
destinations for the current multiviewer’s monitor wall destinations.
