110
System Configuration
Setting the System Name
Only lower-ASCII characters are allowed in the system name. Braces and tilde are not
allowed.
10 Click
Save
.
The new settings are saved locally, and XAdmin reminds you to click
Apply Setting
before closing your session.
11 Click
OK
.
The
Apply settings
button becomes available.
12 Click
Apply settings
.
The multiviewer must restart for changes to the network configuration to take effect. A
message appears prompting you to restart the system immediately.
13 Click
OK
.
Note:
Under
Ethernet
, you may review the IP addresses, network mask,
gateway settings, and the detected connection speeds and duplex modes.
Should you wish to make any further changes to the network settings, you
may find it more convenient to use XAdmin’s System configuration page,
from now on.
Note:
Settings cannot be applied to a multiviewer system while an
upgrade is in progress. If the multiviewer does not restart after 10 seconds
or so, try clicking
Apply settings
again after a minute or two.
