Belden GRASS VALLEY KALEIDO-MX 1RU, Инструкция по установке и обслуживанию

Страница: 37 / 164

37
Kaleido-MX (1RU)
Installation & Service Manual
6 Connect a reference source (if available) to one or more reference inputs.
7 Connect the controller card’s ETHERNET 1 port to your Ethernet switch (see Cabling
Diagram , on page 39).
8 Connect the output cards’ ETH ports to your Ethernet switch.
You can now proceed with the networking setup (see Step 2: Networking Setup , on
page 43).
Note:
A reference is optional but, if minimal processing delay is required for
your monitoring purposes, then you must reference your system. However, if
you must monitor 50 Hz input signals on 60 Hz displays (or vice-versa), then
do not reference your system.
Note:
The Kaleido-MX does not support the controller card’s second
Ethernet port (ETHERNET 2).
IMPORTANT
Make sure to connect your Densité controller and output cards to the same
subnet, and that your Ethernet switch remains isolated from the rest of your
network (consult your network administrator if necessary) until all required
networking setup is complete.