Belden GRASS VALLEY KALEIDO-MX 1RU, Инструкция по установке и обслуживанию

Страница: 59 / 164

59
Kaleido-MX (1RU)
Installation & Service Manual
The selected link mode is applied.
12 Press ESC to return to the previous level in the local control menu.
LINK MODE EDIT appears again on the display.
13 Press the [–] button.
OUTPUT A IP EDIT appears on the display.
14 Repeat step 4 and step 5 to configure the IP address for Output A.
15 Once you have set the IP address for Output A, press the Select button on the front edge
of the output card to exit the control menu.
After a moment, the card restarts. The startup sequence takes approximately four
minutes, during which time the Status LED is first red and then flashing orange.
16 Once the startup has completed, check the card’s Status LED again, and make sure that
it does not indicate an error condition. See Output card Status LED on page 32.
Should the Status LED indicate an error condition, see Card Interfaces , on page 29 to
find out what the other LEDs might be indicating.
17 Verify that the new IP address is effective, by referring to Verifying an Output Card’s IP
Address and Application Version , on page 129.
Notes
• If you do not press any button on the Densité frame local control panel, the
Densité controller will revert to its normal standby mode, and the selected
card's Status LED will revert to its normal operating mode, after 30
seconds.
• If you changed a parameter from the card’s control menu, but have not
applied your change (you did not press the SEL button on the local control
panel), once the 30-second timeout has occurred, the parameters will be
confirmed as if you had pressed the SEL button.