100
System Configuration
Viewing a Multiviewer’s Status Information
7 Click
Save
.
The new settings are saved locally.
8 Click
OK
.
The
Apply settings
button becomes available.
9 Click
Apply settings
.
The Kaleido Multiviewer system must be restarted for changes to the network
configuration to take effect. A message appears prompting you to reboot the system
immediately.
10 Click
OK
.
You will need to edit the XAdmin URL in your Web browser's address bar, in order to log
on to the multiviewer again.
Note:
As required by the IEEE-802.3 standard, section 28D.5, 1000 Mbps
full-duplex communication is only supported via auto-negotiation.
Note:
Settings cannot be applied to a multiviewer system while an
upgrade is in progress. If the multiviewer does not reboot after 10 seconds
or so, try clicking
Apply settings
again after a minute or two, until the
multiviewer reboots.
