24
Installation
Required Materials
• Two cable retainers
• Two WECO mating connectors for each output card (for the analog audio monitoring
outputs), plus one for the CPU-ETH2 controller card’s GPI output:
• Two serial port adapters (one with straight cabling and one with crossover cabling
—
• The
Kaleido Multiviewers Documentation Resource Guide
, which provides instructions on
how to access the documentation you need to install and use your new multiviewer.
See
.
In addition to the above, you might need the following (not supplied):
• Up to 4 displays
• A dedicated 100Base-T Ethernet switch with enough ports for the Kaleido-MX, client
PCs, Kaleido-RCP2, and Audio Bridge Terminals
• Client PC (see below for system requirements)
1RU model
WECO connectors
8 × 1
3
8 × 2
3
16 × 1
3
16 × 2
3
16 × 4
1
24 × 1
3
24 × 2
3
Note:
Due to space constraints at the 1RU rear panel, the 16 × 4 model does
not support analog audio outputs. Audio monitoring is available at the SDI
and HDMI outputs only.
Part number
Adapter cabling
RS-422 pinout at the DE-9P connector
1737-3000-102
Straight
Controller (SMPTE master) mode
1792-3700-100
Crossover
Tributary (SMPTE slave) mode
Note:
In line with our commitment to environmental preservation, only the
Kaleido Multiviewers Documentation Resource Guide
, and some related
documents (e.g., welcome letters, warranty cards) are distributed in printed
form. You can obtain the latest version of the Kaleido Software User’s Manual
and Installation & Service Manual for this multiviewer model, as well as the
Release Notes, from the
Documentation Library
section of the Grass Valley
website. Software, drivers, and sample databases are available from the
Downloads
section of the website.
