52
communicator, the dialer does NOT identify busy signals, and it is therefore recommended to program
the dialer to re-dial several times (default is 3 cycles). This feature is programmable at address 087. A
‘Follow-Me’ feature is applicable only with the dialer; in alarm, Follow-Me number will be dialed first
if communicator is not selected. See explanation in Glossary section.
Note: Upon alarm, the communicator has dialing priority over the dialer.
To cancel the dialer dialing: Arm and Disarm the system.
Programming Telephone Numbers
1. Enter Program mode as described in programming description.
2. Select Dialer or Communicator mode (addresses 201, 202). For dialer selection, enter 00 in
address 201 for Tel. 2, and in address 202 for Tel. 3. (Tel. 1 to 4 is in Dialer mode by default).
If communicator is selected, use both Tel. 2 and 3 (not Tel. 03 only). Tel. 3 is backup for Tel. 2.
3. Enter the required telephone numbers (maximum 16 digits) at address 010 to 013. For example
program Tel. 1 to be 00972-36816767; Press 010, the two left LED's blink, enter the number
00972 in sequence, hold-down ‘0’ (pause), enter 36816767; wait for ‘u’ confirmation.
To insert * in the telephone number; Hold-down keys # and * (panic); * will be displayed as ‘A.’(* is
valid during dialing in DTMF mode).
For Pause during dialing hold-down key ‘0.’ Note: Two pauses (one following the other, or a pause
at the end of telephone number) will not be identified by the system. Total 4 pauses per one number.
4. To quit programming mode Hold-Down key ‘9’.
2.9.1
Deleting Telephone Numbers
1. Enter program mode, confirmed by ‘P’ in display.
2. Press 010 (address for telephone No. 1). At 3 LEDs blinking, hold-down key ‘9.’
3. Follow same procedure for the telephone requiring deletion.
2.9.2
User Programming of
‘
Follow-Me
’
Telephone Number
To program the Follow-Me number, disarm the system (‘USE’ mode).
1. Hold down key [6] twice; wait for three LEDs blinking.
2. Enter Telephone Number (maximum 16 digits and 4 pauses), and wait until all LEDs stop
blinking. The ‘Follow-Me’ number is now programmed.
3. To delete ‘Follow-Me’ number, access ‘Follow-Me’ programming mode as described in paragraph 1,
but do not enter any digits.
To program the system to automatically erase ‘Follow-Me’ number after Disarm, see Address 071 on
Programming Sheet.
During alarm, the system will dial to the programmed telephone and siren will be heard. By connecting
SVM speech module, message will be heard.
