24
When Group Bypass is selected, the sounder and LEDs react as follows:
Shunt LED stops blinking 8 seconds after Arming, (prevents LED light from disturbing sleepers near
the keypad).
There is no exit/entry delay-warning sounder; also, the keys beep disabled (prevents noise
considering sleepers). At Group Bypass mode the keys entry are not causing beeps.
There is no "beep" at the keypad until an alarm occurs, or until Group Bypass is canceled.
When the keypad LEDs turns off after Arming (requires programming), touching the
keypad will activate the LEDs for 5 seconds.
When PRO panel used with AV-707B (with extra three buttons) press * then hold-down ‘A’ or ‘B’ or
‘C’. A represents group 1, B represents group 2 and C both groups.
Group Bypass with code (requires programming): Press key ‘0.’ While four LEDs are blinking, enter
valid user code. When only 2 left-most LEDs are blinking, press ‘0’ key again, ‘h’ will be displayed
and ‘Shunt’ LED will remain blinking to confirm Group Bypass. Enter your user code to Arm
system. Note: complete this operation within 20 seconds, or Group Bypass will be voided.
This
feature is not valid with PRO version.
Group Bypass (HOME) Improved Operation Mode
A. If Group Bypass selected (by pressing 0 and 0) the Shunt LED stops blinking 8 seconds after
arming. This will prevent the LED light from disturbing sleepers near the keypad.
B. There is no exit/entry delay-warning sounder at the keypad.
C. There is no ‘beep’ at the keypad until an alarm occurs or until cancel of Group Bypass.
D. When the keypad LEDs turns off after Arming (requires programming), touching the keypad will
activate LEDs for 5 seconds.
1.2
Hold-Down Functions
Holding down the key for approximately 2 seconds gives access to hold-down functions.
Hold down functions is confirmed by a prolonged beep.
Hold-Down Functions:
1
Siren
Key 1
SIREN TEST
2
Shunt
Display
Key 2
SHUNT DISPLAY
Displays shunted zone(s).
3
Status
Key 3
STATUS DISPLAY
Displays troubled or malfunctioning zone(s).
