33
1.7
Arming and Disarming
1. Make sure that all burglary zones are closed. Delayed zone can remain open prior to arming.
2. The green Status LED indicator is not blinking while all zones are closed.
3. Green indicator will blink when a zone is troubled. Hold-down key 3 for troubled zone display.
An open delayed zone (exit zone) will also cause indicator to blink.
(3 lines) indicated at arming of system if instant zones or 24-Hour zones are troubled (blinking
Green LED indicator followed by
in display and 5 warning beeps); open zones will then be
displayed.
4. To bypass a zone, press key 0 (Bypass Key), followed by the number of the zone.
To bypass a pre-programmed group of zones (requires programming), press 0 twice (short press).
A bypassed zone will not cause alarm if troubled.
5.
Arming:
Enter the Arm/Disarm code (No. 1 default code is 1,2,3,4), the Red Armed indicator will
light up. If any zone (not Delayed or Follower) is troubled,
will be displayed and system will
remain Disarmed.
System Arming is disabled if any Instant zone is troubled.
6.
For Instant Arming
, press key 5 (if previously programmed). See address 071.
Red ‘Armed’ indicator should light up. The system is now armed.
7.
Disarming:
you may have to hold-down key 9 (reset) to clear any previous key presses, and then
enter arm/disarm code (or turn optional key-switch); the Red ‘Armed’ indicator will go off.
Alarm history will be displayed upon disarming. Enter Arming/Disarming code to stop 24H alarm
during Disarm mode.
8.
Keypad Keys self-locking:
In Armed and Disarmed mode, after 6 attempts to enter fault code, the
keys will not react to any key press. This prevents code learning or other code break exigency.
After a 30 second delay, the keys will revert to code entry mode. Each new erroneous code will
lock system for another 30 seconds. Refer to Section III paragraph 3.6 for
‘Remote Arming and
Disarming’
and ‘
Auto-Arming.
’ (Auto-Arming is available beginning with version 2.08).
9.
Ambush Disarming:
In the event that user is forced by an intruder to disarm the system, the
Ambush alarm can be activated. Disarming the system with the Ambush code will cause the
system to disarm and simultaneously send a silent ambush alarm signal to central Station. This is
an optional feature. Ambush Disarming is enabled if communicator selected and the Forced
Disarming code entered (refer to communicator codes programming table). If Contact ID selected,
communicator code setting is not required; the communicator will send code 021.
10. Arming with automatic group bypass; refer to 3.10 paragraph. With AV-707B keypad the arming
and group bypass (three groups) is possible by pressing one key.
